ATtinyX5 - bridge
This is not a standalone shield - it connects the breakout board with the actually shield and puts a resistor on each data pin. It is pretty useful, because that means that the actually shield does not need the resistors and you can make different bridges with different resistor values (depending on the input voltage, the kind of LED used, etc.)
Parts List
| 5 | Resistor | value depends on purpose - see table below |
| 1 | PCB |
 |
 |
 |
 |
 |
 |
 |
 |
Resistor Values
| 10kΩ ¼W - brownblackorangegold |